[Zhongbo.com] There are two kinds. One is to put the flat glass on the glass washer. After the glass is driven by the drive roller, the glass enters the brushing chamber, is brushed by the water spray brush, then enters the washing chamber and is rinsed with pure water. Then, enter the air-drying room and use a special high-pressure fan to completely peel off the water film to achieve a dry and clean cleaning effect. The type of glass cleaning machine is characterized by power saving, but there is noise. Another type is that after the brushing chamber and the flushing chamber, only the breeze is blown, and the electric heating drying system is added to achieve a dry and clean cleaning effect, which is characterized by more power consumption and less noise. There are vertical and horizontal types of glass washers. The vertical footprint is small and the work efficiency is low. The horizontal area is slightly larger and the work efficiency is high. Precautions: (1) Be sure to pay attention to first open the blower and then open the heater. Turn off the heater first, then turn off the blower. (2) When the thickness of the glass plate changes, the height of the wind knife must be adjusted first, otherwise it will cause damage. (3) Before stopping the transmission of the motor, be sure to lower the speed regulator to zero. (4) There is an emergency stop button on the console, which can be used in case of emergency. (5) The glass must be placed within the limit of the feed section. (6) When adding tap water to the washing water tank, the water level should not exceed 250MM. When the water level is lower than 200MM, water should be added in time. Men'S Tops,Men'S Shirts,Men'S Blazer,Men'S Outwear Shaoxing Yidie Garment Co.,Ltd , https://www.yidiegarment.com